Ballyfoyle : Stone Circle

CountyWicklow
Grid RefO 035 161
Longitude6° 27' 5.54" W
Latitude53° 11' 7.11" N
ITM east480366
ITM north584435
Nearest TownBlessington (5.9 Km)
OS Sheet56
UTM zone29U
UTM x449041
UTM y5761192
Hide map  (N.B. Google Maps & GPS readings are slightly out of sync - position is approximate)
Show inline map (by Google Maps)

Visit Notes

Sunday, 15th September 2002

Looking at the OS map at where this circle was supposed to be I didn't really hold out much hope of seeing anything. Just as well really, because it is ruined.

I think I identified a couple of stones from it, and that is all.

Click Thumbnail to View Full Size Image

__

Like this monument

Marked Sites

Directions

Take the N81 south from Dublin and turn left at the Kilbride junction along the R759. Continue through Kilbride and on for another 4.5km where you will find a road to the right. Take this and then at the next junction go right again. 1km along this road you will reach atrack on the right that leads upto Ballyward woods. Park near the gate and enter the woods. Take the left track and continue around the woods always bearing right. You will pass a ruined cottage and a road to the left. Continue past these until the woods thicken up again on your left. The circle remains are just in the woods to the right. Good luck!

Random Gazetteer

A Selection of Other Stone Circles

About Coordinates Displayed

This is an explanation of (and a bit of a disclaimer for) the coordinates I provide.

Where a GPS figure is given this is the master for all other coordinates. According to my Garmin these are quite accurate.

Where there is no GPS figure the 6 figure grid reference is master for the others. This may not be very accurate as it could have come from the OS maps and could have been read by eye. Consequently, all other cordinates are going to have inaccuracies.

The calculation of Longitude and Latitude uses an algorithm that is not 100% accurate. The long/lat figures are used as a basis for calculating the UTM & ITM coordinates. Consequently, UTM & ITM coordinates are slightly out.

UTM is a global coordinate system - Universal Transverse Mercator - that is at the core of the GPS system.

ITM is the new coordinate system - Irish Transverse Mercator - that is more accurate and more GPS friendly than the Irish Grid Reference system. This will be used on the next generation of Irish OS maps.

Valid CSS Valid HTML
Page loaded from cache: (Generation time: December 16 2017 14:02:29.)
Top of page | Feedback | About this site
© Copyright Tom FourWinds 2001-2017