Caheravart : Cross

CountyCork
Grid RefV 675 509
Longitude9° 54' 59.64" W
Latitude51° 41' 42.03" N
ITM east480366
ITM north584435
Nearest TownEyeries (2.6 Km)
OS Sheet84
UTM zone29U
UTM x449041
UTM y5761192
Hide map  (N.B. Google Maps & GPS readings are slightly out of sync - position is approximate)
Show inline map (by Google Maps)

Visit Notes

Sunday, 5th September 2004

I was heading around to see the standing stone and wedge tomb in Kilmackowen townland when I saw the signs for 'Caheravart Eraly Settlement' so I followed them.

A short walk across two boggy fields leads you to a very overgrown site. It's impossible to tell what else was once here, but there are many low grave markers in the grass and brambles ready to trip you up. Erected in the centre of these is a plain cross.

The site is on a south facing slope and built on the top of a flat shelf formed by a rock outcrop.

Standing stones, also called menhirs or monoliths, are the most simple of megalithic monuments. They are exactly what they say, a stone that stands with one end set into the ground. Being simple in form does not make them simple to understand, for they have served several purposes over time. Some were placed to mark burials, others were probably erected to mark boundaries or travel routes, the purpose of others is uncertain, but it may well have been ritual.

Standing stones can vary enormously in size from a under 1m tall to over 4m. Some have been purposely shaped (see Stone Of Destiny (County Meath)) and some must have been chosen purely for their shape (see Ballyvatheen (County Kilkenny)). Most standing stones are dated to be from the Bronze Age, but some are clearly older, especially those associated with passage tombs such as at Knowth (County Meath) and Loughcrew - Corstown (County Meath).

Others have been re-used in later times (see Kilnasaggart (County Armagh) and Breastagh (County Mayo)), perhaps to try and capture some of the powers of the old gods or to legitamise a claim to land.

Wedge tombs are most easily catagorised by their main characteristic - they are taller and wider at the entrance than they are at the rear. Like court tombs they have a gallery which is split either by septal slabs or sill stones into smaller chambers. Galleries can be anything up to 8m in length.

The side walls are, uniquely, made of two rows of stones (three in some cases), which is refered to as double or triple walling. This double walling is perhaps the best feature to identify a wedge tomb by.

The roofs are constructed by laying large blocks or slabs across the gallery, resting on the tops of the walls.

They are often quite small, an amazing exception being Labbacallee (County Cork), one of the largest in Ireland. It is very rare to find a wedge tomb with its roof still in situ, although, occasionally, one or two of the roof slabs are present (see Proleek (County Louth)).

In some examples the roof would have extended beyond the front closing slab forming a portico at the front, which in a few specimens was split by a vertical stone place centrally in the entrance.

Like court tombs, portal tombs and passage tombs they were covered by a cairn, which, at many sites, it is still often possible to determine. A few, such as Burren SW (County Cavan), still retain a large proportion of the cairn.

Click Thumbnail to View Full Size Image

__

Like this monument

Marked Sites

Random Gazetteer

A Selection of Other Crosses

About Coordinates Displayed

This is an explanation of (and a bit of a disclaimer for) the coordinates I provide.

Where a GPS figure is given this is the master for all other coordinates. According to my Garmin these are quite accurate.

Where there is no GPS figure the 6 figure grid reference is master for the others. This may not be very accurate as it could have come from the OS maps and could have been read by eye. Consequently, all other cordinates are going to have inaccuracies.

The calculation of Longitude and Latitude uses an algorithm that is not 100% accurate. The long/lat figures are used as a basis for calculating the UTM & ITM coordinates. Consequently, UTM & ITM coordinates are slightly out.

UTM is a global coordinate system - Universal Transverse Mercator - that is at the core of the GPS system.

ITM is the new coordinate system - Irish Transverse Mercator - that is more accurate and more GPS friendly than the Irish Grid Reference system. This will be used on the next generation of Irish OS maps.

Valid CSS Valid HTML
Page loaded from cache: (Generation time: December 11 2017 21:02:05.)
Top of page | Feedback | About this site
© Copyright Tom FourWinds 2001-2017